Needed Materials:
Chain, wire, canopy and canopy hardware
Weave provided wire whip from light through chain
Wire installed in chain
Gather canopy and provided hardware
Install provided canopy loop into canopy as shown
Install locking washer on canopy loop at back of canopy
Install and tighten canopy loop with provided nut
With a pair of plier bend opened end of chain open to
about ¼ inch.
Feed wire through canopy loop opening at center
Feed about 4 inches of wire through canopy as shown
Install chain at canopy loop
Bend chain back into place after installing into canopy
loop
View of installed chain at canopy
Separate 2 strands of lamp wire at canopy
Separate about 3 inches of wire
Using wire strippers strip about ¾ inches of wire at
each separated wire end
View of first wire separated
View of both wires separated
If not already completed strip both black and white
wires at ceiling electrical box
**NOTE: MAKE SURE CURRENT IS TURNED OFF BEFORE WORKING
WITH WIRE**
Thread longer 1 inch screws into threaded middle hole
at each end of canopy mounting
plate
View of both screws started at proper locations in
mounting plate
Tighten screws as shown
Place shorter screws provided into variable slot at each
end of canopy mounting plate
Using a power drill or screw driver install canopy plate
into ceiling electrical box
**Note: As many boxes are different make sure you
install at proper mounting holes in ceiling box**
View of canopy plate installation
Another view of canopy plate installation
Twist 1 wire from electrical box into one wire from
light fixture
Install provided wire nut at newly joined wire
Repeat for 2nd set of wires
View of installed wire nuts over wires
Install canopy over canopy mounting plate
Using pliers tighten ceiling canopy to ceiling using
provided decorative nuts
View of installed canopy, canopy hardware, and chain
